mibuso.com

Dear all,

I've been searching through the board but I didn't seem to find a perfect solution for that.
I create a report in classic & save as into the PDF using excel. for that I erase the existing file & then save with the same name on the same location.
I used ProcessingOnly property for that so that the same report I run from RTC.

Now when I run the report from classic it runs perfectly. (To delete the existing file & then regenereate the file with the same name etc...)

But when I run the report from RTC, the system is not deleting the existing file.
(may be ERASE function is not working in RTC) & its asking me for replacing the file.....

Note : I dont want to use Temporary path in this case.

Can anybody help me please?.........

Thanks in advance!!!

Best Regards,
Kavita B.

So are you using a processingonly report in RTC?
If it's correct pay attention that RTC refers to files of the NAV Server instead of Client files.
Have you considered this in your process?

Thanks alot dear

I have set only server path. Its working.
Thanks alot

You're welcome!